The short answer
A dryer needs two things: heat and airflow. If yours heats but takes two or three cycles, airflow is almost always the problem. Hot moist air has to get out. When the vent path is clogged with lint or crushed, the moisture stays in the drum and clothes stay damp no matter how long it runs. The good news: the most common causes are outside the dryer itself.
The common causes
- Lint trap and trap housing. The screen should be cleaned every load, but lint also builds up down inside the housing where the screen sits. Fabric softener sheets leave a film on the screen itself: wash the screen with hot soapy water if water stops passing through it.
- Clogged or long vent run. Lint collects at elbows, at the wall connection, and at the outside hood. A vent that runs a long way or turns a lot clogs faster.
- Crushed or kinked vent hose. The dryer gets pushed back against the wall and the flexible hose folds flat. Very common, and free to fix.
- Blocked outside vent hood. The flap outside should open fully when the dryer runs. Lint mats, nests and shrubs block it.
- Overloading and mixed loads. A drum packed tight cannot tumble, and air cannot move through the clothes. Heavy items mixed with light ones also dry unevenly.
- Washer leaving clothes too wet. If the washer is not spinning properly, clothes go in soaking and the dryer gets blamed. Check: clothes should feel damp, not dripping.
- Weak heating element or cycling thermostat (less common). It heats, but not to full temperature, or it cuts heat too early. This one needs testing.
Safety note worth saying out loud: lint build up is a fire risk, not just a drying problem. A dryer that takes too long and a vent you have never cleaned is the combination to take seriously. Keep the path clear.
What you can safely check
- Clean the lint screen, then run water over it. If water pools instead of passing, scrub it.
- Run the dryer empty and go outside: you should feel a strong flow of warm air at the hood and see the flap open fully. Weak flow means a blockage somewhere in the run.
- Pull the dryer out a little and look at the hose: not crushed, not kinked, connected tight at both ends.
- Try one medium load of similar items. If that dries in one normal cycle, the machine is fine and the load was the problem.
- Unplug before reaching into the vent connections, and never run the dryer disconnected from the vent indoors, that just pumps the moisture and lint into the house.
When it is time to call
If the vent is clear, the flow outside is strong, and loads still take two cycles, the problem is inside: element going weak, a thermostat, or a blower issue. That is a test and diagnose job, and it is what dryer repair in Knoxville covers. Call Knoxville Appliance Pros at +1 865-290-1860, Mon to Sat 7am to 7pm. Diagnosis first, price before any work starts.
If your problem is instead a dryer with no heat at all, see our guide to a dryer not heating.
FAQ
Q: How long should a normal load take?
A: Roughly 40 to 60 minutes for a standard load on a normal cycle. Two full cycles for one load is the sign something is wrong.
Q: Is it the dryer or the washer?
A: Squeeze a towel straight out of the washer. If it drips or feels heavy and soaked, the washer spin is the real problem. If it feels evenly damp, look at the dryer vent first.
Q: How often should the vent be cleaned?
A: The screen every load, the full vent run about once a year, more often for long runs.
Q: What does a repair like this cost?
A: Many slow dry fixes are cleaning and vent work, not parts. When parts are needed, typical appliance repairs nationally run about $100 to $400. See the breakdown in our Knoxville appliance repair cost guide.